O-IGAP-6620+

Industrial Dual RF in IEEE 802.11 a/b/g/n Wireless Access Point with 2x10/100/1000Base-T(X)

Anewtech-wireless-access-point-O-IGAP-6620-Oring-Industrial-Ethernet-Switch

Features

  • High Speed Air Connectivity: Dual RF in IEEE 802.11 a/b/g/n WLAN interface support up to 300Mbps link speed
  • Dual RF for redundant wireless communication
  • Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
  • Support Long Distance Air Connectivity
  • Support X-Roaming < 60 ms
  • Support wireless load balance
  • Support external SMA antenna installation
  • Support Dual AP/Dual Client /Bridge /AP-Client Mode
  • Support MAC/IP/Port Filter
  • Provide Digital Input and Digital Output
  • Wireless connecting status monitoring
  • Secured Management by HTTPS
  • 1KV isolation for PoE P.D.H

Datasheet

O-IGAP-6620.pdf

Enquiry

sales@anewtech.com.sg

Specification

Physical Ports
10/100/1000 Base-T(X) Ports in RJ45 Auto MDI/MDIX 2
5-Pin Terminal Block 2(DI x 4 and DO x 4) :
Dry Contact:
On: short to GND, Off: open
Wet Contact (DI to COM/GND):
On: 0 to 3VDC, Off: 10 to 30VDC
PoE P.D. Port Present at ETH2
Fully compliant with IEEE 802.3af Power Device specification
Over load & short circuit protection
Isolation Voltage: 1000 VDC min.
Isolation Resistance : 108 ohms min
WLAN Interface
Operating Mode Dual AP/Dual Client /Bridge /AP-Client Mode
Antenna and Connector 4 x reverse SMA Female
Radio Frequency Type DSSS, OFDM
Modulation IEEE802.11a : OFDM with BPSK, QPSK, QAM, 64QAM
IEEE802.11b: CCK, DQPSK, DBPSK
IEEE802.11g: OFDM with BPSK, QPSK, 16QAM, 64QAM
IEEE802.11n : BPSK, QPSK, 16-QAM, 64-QAM
PoE P.D. Port Present at ETH2
Fully compliant with IEEE 802.3af Power Device specification
Over load & short circuit protection
Isolation Voltage: 1000 VDC min.
Isolation Resistance : 108 ohms min
Transmission Rate IEEE802.11b: 1 / 2 / 5.5 / 11 Mbps
IEEE802.11a/g: 6 / 9 / 12 / 18 / 24 / 36 / 48 / 54 Mbps
IEEE801.11n: up to 300Mbps
Transmit Power 802.11a: 12dBm ± 1.5dBm@54Mbps
802.11b: 17dBm ± 1.5dBm@11Mbps
802.11g: 16dBm ± 1.5dBm@54Mbps
802.11gn HT20: 15dBm ± 1.5dBm @MCS7
802.11gn HT40: 14dBm ± 1.5dBm @MCS7
802.11an HT20: 12dBm ± 1.5dBm @MCS7
802.11an HT40: 11dBm ± 1.5dBm @MCS7
Receiver Sensitivity 802.11a : -76dBm ± 2dBm@54Mbps
802.11b : -85dBm ± 2dBm@11Mbps
802.11g : -76dBm ± 2dBm@54Mbps
802.11gn HT20:-75dBm ± 2dBm@MCS7
802.11gn HT40:-72dBm ± 2dBm@MCS7
802.11an HT20:-74dBm ± 2dBm@MCS7
802.11an HT40:-71dBm ± 2dBm@MCS7
Encryption Security WEP: (64-bit ,128-bit key supported)
WPA/WPA2 :802.11i(WEP and AES encryption)
WPAPSK (256-bit key pre-shared key supported)
802.1X Authentication supported
TKIP encryption
Wireless Security SSID broadcast disable and enable
Protocol Support
Protocol ARP,BOOTP, DHCP, DNS, HTTP, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP, RSTP
LED Indicators
Power Indicator 3 x LEDs, PWR1(2)(PoE) / Ready:
Red On : Power is on and booting up
Green On : Power is on and functioning Normal
10/100/1000Base-T(X) indicator 2 x LEDs,
LNK/ACT:Green for port Act.
Speed: Green for port Link at 1000Mbps
Amber for port Link at 100Mbps.
Off for port Link at 10Mbps
WLAN LED 2 x Green Solid On: RF on, Blink: data transmitting
2 x Green for WLAN work on 2.4GHz
2 x Green for WLAN work on 5GHz
Power
Input Power Dual DC inputs. 12~48VDC on 6-pin terminal block
Power Consumption (Typ.) 11 Watts
Physical Characteristics
Enclosure IP-30
Dimensions (W x D x H) 74.3(W) x 109.2(D) x 153.6(H) mm (2.93 x 4.3 x 6.05 inch.)
Weight (g) 1250 g
Environmental
Storage Temperature -40 to 85°C (-40 to 185°F)
Operating Temperature -10 to 60°C(14 to 140°F)
Operating Humidity 5% to 95% Non-condensing
Regulatory Approvals
EMI FCC Part 15, CISPR (EN55022) class A, EN50155 (EN50121-3-2, EN55011, EN50121-4)
EMS IEC61000-4-2 (ESD), IEC61000-4-3 (RS), IEC61000-4-4 (EFT), IEC61000-4-5 (Surge), IEC61000-4-6 (CS), IEC61000-4-8, IEC61000-4-11
Shock IEC60068-2-27, EN61373
Free Fall IEC60068-2-31
Vibration IEC60068-2-6
Safety EN60950-1